-
$11.49Convenient Parts Kit to make one Whirligig figure from either pattern #WGC3 (Wild Action Whirligigs) or pattern...
-
$5.99This whirligig parts kit is used for pattern #WGC2 The Wild Birds as well as our Flying Carrot Whirligig...
-
$5.99Convenient Parts Kit for our pattern #WGC156 Whirligig Collection, #WGC4 Wacky Fun Whirligigs and #W2199 Dragonfly...
-
$12.99Save time and money plus get professional-looking results by using our Whirling Wing Parts Kit. Included in...
-
$12.99Give your Hungry Bass whirligig project (W1166WG) that professional look. This kit includes all the hard-to-find...
-
$12.99Give your Whiffing Golfer whirligig project (W1167WG) that professional look. This kit includes the wood ball plus...
-
$9.95This Kit contains the wood and metal parts to complete one whirligig. Includes two wood hubs, the pre-drilled center...
-
$5.99Keep your whirligigs turning smoothly in the wind! Enough brass parts to make four whirligigs. [This Kit was...
-
$9.99Hardware kit contains enought brass screws and center tubes to make the ten spinning whirligigs in pattern #WGC9,...
-
$5.99All the wooden hubs, swivels and eyescrews to make both the Seahorse and the Mermaid.
-
$15.99Includes the brass driveshaft, nuts and washers, brass drive wire and eyescrew plus the specialty plastic hardware...
-
$4.99Includes the specialty hardware to make three weathervanes. [This Kit was developed for our Winfield Collection...
-
$6.49Convenient Parts kit for both our Windmill Patterns #MILL and #MILL2. Includes the 6" lazy susan, lag bolt, 2...
-
$11.99The Parts Kit for our Crazy Spinners includes the center steel shaft, turn sleeves, axle nut, plus shaft clamps with...
-
$6.49Includes Washers, Bearings & Screws to make 4 Whirly Wheelz Mobiles! [This Kit was developed for our Winfield...
-
$69.99**SAVINGS OF $10 WHEN PURCHASING THIS KIT COMPARED TO PURCHASING THE PARTS INDIVIDUALLY**...
-
$8.99Save time and money plus get professional-looking results by using our Giant Whirligig Flowers Parts Kit....
-
$1.99Kit contains (5) each of Swivels and Eye Screws.
-
$8.99Parts needed to complete one Spinner design from Pattern #7168SC. [This Kit was developed for our Winfield...
-
$4.95Contains brass machine screws, washers, nuts and grommets to make FIVE Copper Pinwheels (either 12" or 6" size) from...
-
$4.95Parts to make 3 Twisters.
Skip to main content
