Ridiculous Rooster Birdhouse Pattern

Hang this unique project from a tree limb using wire and an eye screw or mount on a fence or tree trunk using our Flush Mount Hangers (available below). The bottom is hinged for easy clean out when nesting season is over.

This fun project is easy to make from our full-size pattern and step-by-step instructions. Uses two brass plated hinges (#BHNG1) available below. (16" tall)

More Info

Wood:
One 1X12 x 84" long pine board.
One 2X4 x 4-7/8" long pine board.

Tools:
Table saw or circular saw and band saw or scroll saw with a smooth non-chipping blade, drill and 1-1/2", 3/16" and 3/32" dia. drill bits.

Hardware:
Nails - One box, 3D 1-1/4" long, finish.
Hinge - Two 1" x 1-1/16" brass plated (1 pack #BHNG1).
Eyescrew (optional) - One 5/16" I.D. (#EYE3).
Flush Mount Hanger (optional) - One 1-3/4" x 1-1/2" (#FMH).
Screw - Ni ne #8 x 1-1/2" long, flat head.

Supplies:
Transfer paper (#CARB), pencil & clear tape.
Sand paper - medium & fine grits.
Wood Glue - exterior (#GLUETB3).
Wood filler - non shrinking, fast drying for wood flaws.
Paint brushes - 2", 1" and fine detail.

Paint:
White water base primer (#PRIMQT) for a base coat and the following suggested colors of Delta Craft paint:
2015 - Purple
2030 - Burnt Sienna
2076 - Crimson
2471 - Hunter Green
2483 - Azure Blue
2505 - White
2506 - Black
2459 - Crocus Yellow

Sealer:
High-grade, non-yellowing, semi-gloss UV protected project sealer (#POLYQT) for outdoor protection.