Goofy Gull Birdhouse Pattern

Hang this unique project from a tree limb using wire and an eyescrew or mount on a fence or tree trunk using our Flush Mount Hangers (available below). The bottom is hinged for easy clean out when nesting season is over.

This fun project is easy to make from our full-size pattern and step-by-step instructions. Uses two brass plated hinges (#BHNG1) available below. (20" tall)

More Info

Wood:
One 1X10 x 84" long pine board
One 2X4 x 4-5/8" long pine board

Tools:
Table Saw and Band Saw or Scroll Saw with a smooth non-chipping blade
Electric Drill and 1-1/2", 3/16" and 3/32" dia. drill bits

Hardware:
Nails - One box, 3D 1-1/4" long, finish
Screws - Eight #8 x 1-1/2" long, flat head
Hinges - Two 1" x 1-1/16" brass plated (#BHNG1)
Eyescrews (optional) - One 5/16" I.D. (#EYE3) for hanging
Flush Mount Hanger (optional) - One 1-3/4" x 1-1/2" (#FMH)

Supplies:
Transfer paper (#CARB), pencil & clear tape
Sand paper - medium & fine grits
Wood Glue - exterior grade (#GLUETB3)
Wood filler - non-shrinking, fast drying for wood flaws
Paint Brushes - 3/4", 1/4" and 2" wide brushes

Paint:
White primer (#PRIMQT) for a base coat and the following suggested colors of acrylic paint or exterior semi-gloss enamel:
2030-Burnt Sienna
2057-Quaker Grey
2078-Straw
2436-Charcoal Grey
2459-Crocus Yellow
2505-White
2506-Black

Sealer:
High-grade, non-yellowing, semi-gloss UV protected project sealer (#POLYQT) for outdoor protection.